LED High Power Dual Array Red/Near-InfraRed 660/850 nanometers

High-power LED Dual Array Red/Near-InfraRed 660nm/850nm.

If you can only get one of our LED arrays, get this. It has the widest spectrum of use and will give you the most benefits. We have another version for $219, but it only puts out a fifth of the light that this one does.

32 High-power 660nm Red LEDs speed healing of wounds and infections, penetrate about 1-2″, increase cellular ATP and energy while reducing pain and stimulating collagen repair.

24 850nm High-power Near-infrared LEDs for deeper penetration (around 3-5”) and more pain relief than visible red. (Note: Our eyes cannot see NIR. The small indicator light shows that the device works.)

Made in USA. Lifetime warranty (excluding physical damage).

From space to you! Based on NASA research on healing with LED lights. Safe, effective, affordable LED light can speed healing, soothe sore muscles, ease chronic pain, relieve stiffness, and increase circulation. This non-drug alternative treatment will amaze you with rapid effects.

Our new High-power LED Dual Array Red/Near-InfraRed puts out 5 times the light of our standard switchable 120 LED dual array. This means that it will have the same effect in 1-2 minutes that it takes standard arrays to do in 5-10 minutes. It also penetrates deeper.
Note: This array has only an on/off switch so both wavelengths shine at the same time. It has a fan to dissipate heat.

32 High-power 660nm Red LEDs speed healing of wounds, infections, and other conditions to a depth of about 2″ by increasing cellular ATP and energy while reducing pain and stimulating collagen repair.

24 850nm High-power Near-infrared LEDs penetrate 3-5” to increase blood flow and release nitric oxide to soothe and heal sore muscles and joints. Also helpful for toning the face and skin.
Note: While NIR light does not harm tissue, it can heat it up, therefore it makes sense to avoid using it directly on the thyroid or eyes.

Note on power and pulsing:
This LED array produces approximately 5 joule per minute per cm2, more light per dollar than any other array we know of. Our High-power LEDs have a rating of approximately 40,000 mcd at 800 mW. This compares favorably with so-called Cold Lasers and Low-level Lasers. They do not pulse because that would add significant cost to the product. For pulsing devices see our Em Pulser and OsteoPad